Clarke Clean Track® L24 56317170 User Manual

Form No. 56043161 - Clean Track
®
L24 - 77
You can select the scrub motor upper and lower current limits to compensate for different brush and/or carpet types.
Thecurrentlimitsettingsrangefrom0to9,with0beingtheleastload/currentdrawand9beingthegreatest.Toselect
the current limit range for a particular scrub mode:
1. Turn the Key Switch (A) to the off position.
2. Press and hold the button combo for the scrub mode you wish to change as listed in the table below.
Scrub Setting Factory Default Button Combo for Programming Programming Indicator
Maintenance Mode 9 Scrub ON & Vacuum Switches Vacuum = Green
(Left) Scrub = Yellow
Restoration Mode 9 Scrub ON & Solution/Pre-spray
Switches
Pre-spray = Green
(Right) Scrub = Yellow
Pre-spray Mode 9 Scrub ON & Detergent System
Switches
Detergent = Green
(Right) Scrub = Yellow
(Left) Scrub = Yellow
3. Whileholdingtheappropriatebuttoncombination,turntheKeySwitchtotheonposition.
4. Continue to hold button combination until the programming indicators light.
5. Release the buttons. The display will now show a scrub brush icon and a number from 0 to 9.
6. Press and release the Scrub ON Switch (J) to toggle through the numbers. (Refer to the table below for the lower
and upper current limits for each setting).
7. Oncethedesiredsettingisselected,presstheScrubOFFSwitch(H) to save this setting. The display will now
show a key icon to indicate the procedure is done.
8. Turn the Key Switch to the off position. The new setting will be saved and will remain in effect until it is changed
again.
Setting Lower Current Limit* Upper Current Limit*
0 15.5 20.6
1 17.7 22.8
2 20.0 25.0
3 22.2 27.3
4 24.4 29.5
5 26.6 31.7
6 28.8 33.9
7 31.1 36.2
8 33.3 38.4
9 35.5 40.6
*Combinedcurrentofbothscrubmotors

Clarke Clean Track® L24 56317170 Specifications

General

Brand	Clarke
Model	Clean Track® L24 56317170
Category	Floor Machine
Language	English