To Next PageTo Next Page
Need help?Do you have a question about the Clay Paky Sharpy and is the answer not in the manual?
Ensure proper installation, stable anchorage, and safety chain usage.
Maintain safe distances, observe temperature limits, IP rating, and surface temperature.
Proper earthing, mains connection, and safe lamp handling procedures.
Eye safety, non-residential use, battery, and disposal compliance.
Details the items included in the projector package.
Instructions for locking and releasing the PAN movement mechanism.
Instructions for locking and releasing the TILT movement mechanism.
Describes how to install the projector on floors, trusses, ceilings, or walls.
Step-by-step guide for connecting and disconnecting the power cable.
How to connect the projector to the main power supply.
Instructions for connecting the DMX control signal cable.
Procedure for switching on the projector and initial display information.
Configure DMX address, channel mode, fixture ID, and network settings.
Adjust lamp control, safety, movement inversion, and homing modes.
View system errors, operating hours, lamp status, and hardware versions.
Control lamp, reset projector, and set channel levels manually.
Perform functional tests for various projector effects.
Access advanced features like firmware upload, setup, and calibration.
Procedures for opening covers, cleaning, and general maintenance.
Detailed steps for lamp change, regulation, and filter replacement.
Extracting effect modules and removing the battery.
Instructions for replacing gobos and managing optional accessories.
Details the heat screen filter and its application.
How to store the C61190 accessory when not in use.
Specifications for power supply, input, output, and lamp types.
Details on motors, channels, inputs, movable body, resolution, and weights.
IP20 rating, CE marking, and safety devices.
Information on cooling system and projector body structure.
Addresses causes and remedies for the projector not switching on.
Troubleshooting for non-operational electronics and defective projection.
Solutions for reduced luminosity due to lamp or optical issues.
Table detailing channels, standard, and vector modes for effects.
Specific bit values and effects for Colour Wheel, Stop/Strobe, Dimmer, Gobo, Prism.
Details on effects movement, frost, focus, pan, tilt, and fine adjustments.
Explains function, reset, and lamp control channels and their bit values.
Timing configurations for channels and a detailed time table.
General| Color Temperature | 8000 K |
|---|---|
| Beam Angle | 0°-3.8° |
| Pan | 540° |
| Gobos | 17 fixed gobos + open |
| Prism | 8-facet rotating prism |
| Weight | 19 kg |
| Colors | 14 colors + open |
| Focus | Motorized |
| Dimmer | 0-100% electronic |
| Strobe | Yes |
| Control | DMX, Art-Net, RDM |
| Power Consumption | 350W |
| DMX Channels | 16 |
