P-03 Temperature Offset setting
After entering P-03, you can set the temperature to the appropriate value by pressing
according to the actual temperature. Long press for speedy setting. Confirm your setting
by pressing .
Temperature Offset range: ±10°C.
Please refer to above description steps to set up P-03.
You can go to next parameter setting by pressing , or pressing key to quit and go
back to measurement mode.
Note:
1. Please make sure the Temperature Electrode is PLUGGED when Temperature Offset setting.
Otherwise, the unit will display “Err” and go back to the set up menu for fresh operation. The
“ATC” will be displayed beneath the main screen the screen normally.
2. It is not working to plug the Temperature Electrode while setting. You have to set again after
plugging in the electrode and quit the current mode.
11
To Next Page
Loading...