20
Storage of measuring data
Browse on data storage
1.If you need to save the measuring data once it is stabilized, press , the Lot no. will be shown
on the upper right of the screen. Press to save the data. You can also press to not save.
The meter will automatically go back to measurement mode after the data saved. The unit
at most can save 200 sets data. The screen will show “OVER” if more than 200 sets reminds you the
memory card is full.
2.Enter into setting mode P-07 if you need to delete the saved data forever. You can refer to
Clearing memory function
1. Press to enter into the browse on the data storage , the Lot no. will be shown and data
twinkling. Press to check all the saved data. Press to go back to measuring mode.
If showed “NONE” means no data is saved yet.
2. If you quit and re-entering during checking the data, the meter will freeze in the last set of data.
5.7 Storage of measuring data
To Next Page
Loading...
Need help?
General