Clean PH200 - P04 Auto Lock Function Setting

After entering P-04, you can select ON or OFF the Auto Lock Function by pressing . If the
Auto Lock Function is ON, the meter can lock the measured value after the reading had stabilized
and display . Press to unlock.
Please refer to above description steps to set up P-04.
You can go to next parameter setting by pressing , or pressing key to quit and go
back to measurement mode.
P-04 Auto Lock Function setting
12
P-05 Prompt tone setting (optional)
After entering P-05, you can select ON or OFF the prompt tone by pressing . If the
prompt tone is ON, you will hear the “Beep” tone after the reading had stabilized when in
calibration.
Please refer to above description steps to set up P-05.
You can go to next parameter setting by pressing , or pressing key to quit and go
back to measurement mode.