Clean PH200 - ORP Set up; Ion Set up

To Next Page

To Previous Page

Below is only the whole meter setting.

Please refer to pH setting for detailed set up steps.

5.4.2 ORP set up

5.4.3 Ion set up

P-01 Measuring unit setting

After entering P-01, you can switch between measuring unit mg/L and ppm by pressing .

Confirm your setting by pressing .

Please refer to above description steps to set up P-01.

You can go to next parameter setting by pressing , or pressing key to quit and go

back to measurement mode.

P-04 Auto Lock

Function setting

P-05 Prompt tone

setting (optional)

P-06 Auto Power

Off Setting

P-07 Reverting to

Factory Default Setting