After power-up, the unit will enter the measurement mode. Factory default is pH measuring
mode. You can switch among the pH measurement mode, ORP measurement mode and the
Ion measuring mode by pressing the Key. In Ion measuring mode, press to enter set
up step. Press to enter calibration step.
After entering P-02, you can select 2 points, 3 points, 4 points, 5 points, 6 points, 7 points for
calibration by pressing . Confirm your setting by pressing .
You can go to next parameter setting by pressing , or pressing key to quit and go
back to measurement mode.
Please refer to above description steps to set up P-02.
After entering P-03, you can select 1 valence,2 valence, 3 valence by pressing . Confirm
your setting by pressing .
Please refer to above description steps to set up P-03.
You can go to next parameter setting by pressing , or pressing key to quit and go
back to measurement mode.
Below is only the whole meter setting. Please refer to pH setting for detailed set up steps.
P-03 Ionic valence setting
16
P-02 Calibration point setting
P-04 Auto Lock
Function setting
P-05 Prompt tone
setting (optional)
P-06 Auto Power
Off Setting
P-07 Reverting to
Factory Default Setting
To Next Page
Loading...
Need help?
General