P-08 Reverting to Factory Default Setting
14
After entering P-08, you can select NO or YES to not reverting or reverting to factory settings by
pressing . If select YES, the meter will revert all the settings to factory defaults and all
the settings will lost forever. The unit will restart at the same time.
Please refer to above description steps to set up P-08.
You can go to next parameter setting by pressing , or pressing key to quit and
go back to measurement mode.
Note:
1. During setting, you can press key to quit setting whenever necessary.
2. During setting, you can adjust anything twinkling by pressing . If it is the data
twinkling, you can speedy adjust the data by pressing .
To Next Page
Loading...
Need help?
General