19
Cleaning Side Brush
1. Check if side brush is broken or something is stuck
2. Clean the side brush
3. If side brush is curly or deform, put them in hot water for 5 seconds
4. If side brush is worn out then please change
Cleaning Dust Bin and Filters
Empty and clean the dust bin before or after every cleaning session. Follow the cleaning steps as below.
Note:
a. Wash the primary filter after every cleaningsession, at least 15-30 days to
maximize its use life.
b. Before installing the primary
filter make sure is is dry.
c. HEPA filter should be replaced if it has lost its shape or no longer fit tight
against the filter frame.
d. Recommended changing intervalls for the HEPA filter:
i. Once per month if the robot is vacuuming seven days a week
ii. Every other month if it is used 3-4 days per week
iii. Every four months if used less than once per week.
A. Hold the bottom of dust bin, and then press down the button
to take out the dust bin
B. Take out of dust bin
C. Open the dust bin
D. Remove the primary and HEPA filter
out and away from the dust bin.
E. Empty the dust bin
F. Flush the dust bin and primary filter, use a cleaning
brush to clean the HEPA-filter, do not use water.
G. Install the dried primary filter and
HEPA-lter back into dust bin
New filters can be bought at www.cleanmate.se or at your local retailer.
To Next Page
Loading...
