Need help?Do you have a question about the Clear-Com CS-100 and is the answer not in the manual?
General| frequency response | 250 Hz - 10 KHz (-3 dB ref. to 1 KHz) |
|---|---|
| headset microphone input level | -55 dBm |
| headphone output level | 9 volts rms into 600 Jl |
| distortion | Less than 0.5% |
| system impedance and level | Approximately -25 dBm into 200 |
| auxiliary input audio level | 100 mv into 600 Jl |
| channel separation (CS-200) | > 45 dB |
| headset input connector | 2 - 4 pin connectors (D4M) |
| interconnect output connectors CS-100 | 6 each in parallel, Switchcraft D3M |
| interconnect output connectors CS-200 Channel A | 3 each in parallel, Switchcraft D3M |
| interconnect output connectors CS-200 Channel B | 3 each in parallel, Switchcraft D3M |
| auxiliary input connector | Switchcraft D3M |
| power supply | 28 volts circuit breaker protected |
| power requirements | 115/230 volts 50-60 Hz. 80 watts maximum |
| capacity | Will support up to 40 RS-100A or MR-102 remote stations or 15 KB-100 or KB-lll remote stations |
Weight and Dimensions| dimensions CS-100/CS-200 | 9.5"L X 4"H X 8.5"D |
|---|---|
| dimensions CS-100K/CS-200K | 19"L X 3.5"H X 9.125"D |
| weight CS-100/CS-200 | 6 lbs. 14 oz. |
| weight CS-100K/CS-200K | 6 lbs. 15 oz. |
To Next Page