13
RS-602/622 BELTPACK
2. Plug the DB-9F plug on the other end of the cable
into the DB-9M serial port socket on a computer.
If your computer has only USB connectors rather than a
serial port, you must purchase a USB-to-serial port
adaptor.
Contact your dealer or the Clear-Com factory for
information about obtaining the beltpack programming
kit, which contains the V-Pack software, VPC-1 cable,
and V-Pack manual. You can also find a PDF of the
V-Pack manual at www.clearcom.com.
Table 1: Pinouts for RS-602/622 Computer Connector
PIN FUNCTION
Tip SDO to computer
Ring SDI from computer
Sleeve Ground
To Next Page
Loading...
