User manual
Page 10 © clearaudio electronic GmbH, 2022-11
2.6
Now you can set the platter carefully onto the bearing. To avoid damage, make sure you slide the
platter slowly and cautiously on the sub-platter/ bearing assembly. Hold the platter securely, so the
platter does not slip or fall on your turntable.
Pic. 8: Setting the platter onto the bearing
2.7
Please check with the bubble level gauge, if your
Performance
DC
turntable is in a level position.
You can adjust each of the turntable’s feet to get the turntable
level. Only if the turntable is in a level position you will get the
best results with your turntable.
Please note:
Through turning the feets clockwise you will raise the turntable,
by turning counter clockwise the turntable will lower.
Pic. 9: Adjustment of the level position
Pic. 9.1: Adjustment of the height
To Next Page
Loading...
