Clearaudio Performance DC - Fitting Bearing Upper Part; Setting Sub-platter and Belt

User manual
Made in Germany Page 9
2.4
Now you can set the bearing upper part carefully onto the bearing. To avoid damages make sure
you slide the bearing upper part slowly and carefully on the polished ceramic shaft.
Pic. 6: Fitting the bearing upper part
2.5
Now you can set the sub-platter carefully onto the bearing (see Pic. 7).
To avoid any damage, make sure you slide the sub-platter slowly and carefully onto the bearing.
After that, take the included belt and place it around the motor and the sub-platter (see Pic. 7.1).
At this point the sub-platter will be higher than the pulley. This is normal, as the CMB requires the
weight of the platter to fully engage it.
Pic. 7: Setting the sub-platter Pic. 7.1: Placing the belt