Versa™ Pro CT
7
QSG-0081-002v1.0 January 2021
Mount the Huddle CTH on a Wall
Select your hardware based on your specific installation needs.
1. Determine location for the Huddle CTH.
2. Use a pencil to mark on the table the location of four mounting holes that
align with the mounting holes on the unit’s mounting ears. If needed, use
a level.
3. With the proper size drill bits, drill four pilot holes for fasteners/anchors.
4. Install the fasteners/anchors in the wall.
5. Align the mounting holes on the Huddle CTH mounting ears with the pilot
holes.
6. Use four #6 or M3.5 screws to attach the Huddle CTH to the wall.
Mount the Huddle CTH Behind a Display
The back of the Huddle CTH includes a 75 mm x 75 mm VESA hole pattern. This
allows the use of a VESA display mount to attach the Huddle behind a display.
VESA display mount kits with a matching standard hole pattern are available
from third parties.
Mounting details are dependent on the specific display and the mounting kit.
To Next Page
Loading...
