ClearOne CONVERGE Huddle

Other manuals for ClearOne CONVERGE Huddle

Quick Start Guide6 pages

Need help?

Do you have a question about the ClearOne CONVERGE Huddle and is the answer not in the manual?

Summary

Chapter 1: Introduction

Installing CONSOLE AI

Instructions for installing the CONSOLE AI application on a Windows PC.

Online Mode vs. Offline Mode

Details the differences between operating CONSOLE AI in online and offline modes.

Chapter 3: Project - Offline

Creating a Project (CP2)

Steps to create a new project for a CONVERGE Pro 2 device.

Creating a Project (Huddle)

Steps to create a new project for a CONVERGE Huddle device.

Chapter 4: Configuration - Offline (Huddle)

Changing Device Settings (Huddle)

Details on how to change device settings for a Huddle device.

Connecting Channels Using FlowView (Huddle)

Instructions on making connections between Huddle audio channels using FlowView.

Connecting Channels Using MatrixView (Huddle)

Guide on visualizing and making connections between Huddle audio channels using MatrixView.

Chapter 5: Adding Devices (CP2)

Adding a CONVERGE Pro 2 Device

Steps to add CONVERGE Pro 2 devices to an existing project.

Changing CP2 Device Settings - General

How to change the general settings for a CONVERGE Pro 2 device.

Changing CP2 Device Settings - Network

Instructions on changing network settings for a CONVERGE Pro 2 device.

Changing CP2 Device Settings - VoIP

Guide on changing VoIP settings for a CONVERGE Pro 2 device.

Changing CP2 Device Settings - IP Phone (VoIP;SIP)

Instructions for changing IP Phone settings for a CONVERGE Pro 2 device.

Changing CP2 Device Settings - Telco

Guide on changing Telco (analog phone line) settings for a CONVERGE Pro 2 device.

Chapter 6: Adding Partitions, Channels, and GPIO Settings (CP2)

Adding Channels to a Project

Steps to add audio channels to a project for configuration.

Chapter 7: Macros and Timers (CP2)

Recording Macros

Instructions on creating macros by recording actions in FlowView, MatrixView, etc.

Adding Macros

Steps to create or modify a macro by typing commands or using the Command Wizard.

Adding and Modifying Timers

Guide on adding, editing, and deleting timers to run macros or reset the stack.

Chapter 8: Managing Channels (CP2)

Connecting Channels Using FlowView (CP2)

Using FlowView to add, connect, and configure audio channels in a project.

Connecting Channels Using MatrixView (CP2)

Using MatrixView to visualize and make connections between audio channels as a matrix.

Chapter 9: Online Mode (Huddle)

Connecting to a Device (Huddle)

Steps to connect to a Huddle device to work in online mode.

Send Project File to a Device (Huddle)

How to send project changes to a connected Huddle device to make them live.

Updating Device Firmware (Huddle)

Steps to update the firmware of a Huddle device using CONSOLE AI.

Chapter 10: Online Mode (CP2)

Connecting to a Device or Stack (CP2)

Steps to connect to a CP2 device or stack to work in online mode.

Live Control (CP2)

How to run macros, presets, timers, or set GPIO pin states when connected.

Loading a Project File to a Device or Stack (CP2)

Procedure for loading a configured project file to a CP2 device or stack.

Commit Changes to Hardware (CP2)

How to commit project changes made in CONSOLE AI to connected CP2 devices.

Updating Device Firmware (CP2)

Steps to update the firmware of a CP2 device using CONSOLE AI.