CONSOLE AI | Adding Devices (CP2) | 124
Note:
The tabs shown on this dialog box depend on the type of device. All devices have General and
Network tabs. Devices with VOIP capability have VoIP and IP-Phone tabs. Devices with Telco
capability have a Telco tab.
3. If it isn’t already selected, select the General tab.
4. (Optional) Change any of the settings (described in the table below).
Option Description
Device Name The name of the CP2 Device as it will appear in the CONSOLE
application.
Serial Number The device’s serial number.
Use Long Distance P-link Specify whether to turn on long-distance P-link, which lets you
increase the distance between P-link devices but reduces the
number of P-link devices that can be added. See About Long-
distance P-link for more details.
Serial Port Settings-Baud Rate Set the baud rate of the serial port.
USB MAC Address-Assign To Specify whether to assign a MAC address to the USB port on
the front panel of the CP2 or to the VoIP VLAN.
Note:
If you decide to assign the MAC address to the VoIP
VLAN, it may make the front-panel USB port unusable
for a telnet connection.
5. If you are done changing the CP2 device settings, click Close.
You can also change other device settings, as described in the following topics:
• Changing CP2 Device Settings - Network
• Changing CP2 Device Settings - VoIP
• Changing CP2 Device Settings - IP Phone (VoIP/SIP)
• Changing CP2 Device Settings - Telco
Changing CP2 Device Settings - Network
You can change the network settings for a CONVERGE Pro 2 device.
To change the network settings for a CP2 device:
1.
From the toolbar, click .
The Devices dialog box appears:
CONSOLE AI User Manual
To Next Page
Loading...
