ClearOne CONVERGE Huddle - Changing Channel Properties - MIC (Huddle)

CONSOLE AI | Configuration - Offline (Huddle) | 77
Option Description
Hold Time How long the channel stays gated on after the audio falls below the
Gate Ratio threshold. The hold time range is from 0.1 to 8.0 seconds.
The default is 0.3 seconds.
Off Attenuation The amount of level reduction applied to a channel when it is gated off.
The range is from 0 to 60dB. The default is 18dB.
Decay Rate How fast a channel gates off after the Hold Time expires. The default is
Medium.
Adaptive Ambient (Auto
Only)
Adjusts the ambient reference level as noise and room conditions
change. When Adaptive Ambient is on, the mic channel monitors
the ambient noise level on the input and adjusts the ambient level
reference automatically. This means that the gate threshold level
automatically increases or decreases based on background noise. The
default is On.
Manual Ambient Tracking
(Auto Only)
The input will use the fixed ambient level you specify inthe Ambient
Level field as its gating reference.
Chairman Override Provides gating priority for this mic input over any other mic input within
the same gating group that is set to Auto gating mode. When a mic
with Chairman Override enabled gates on, all mics which do not have
Chairman Override enabled will gate off. The default is Off.
25.Click Close.
Changing Channel Properties - Mic (Huddle)
You can use channel properties to modify a Mic
channel.
You can make any of the following changes:
Feature Description
Sig Gen Lets you turn on the signal generator for this channel and change the
signal generator settings.
Configure as Line Input Checking this check box removes the PPWR, Coarse Gain, AEC, NC,
AGC/ALC, and Gate settings, leaving only Gain, Mute, and Filter.
PPWR (Phantom Power) Phantom power is an auxiliary power source used to power certain types
of microphones. Phantom power voltage is 24VDC. Default is On.
Coarse Gain The Coarse Gain slider adjusts the volume level for a mic input channel.
Coarse gain can be adjusted in roughly 7dB increments.
Note: In general, you should set the Coarse Gain slider to 56dB
for a mic input, 28dB for active equipment that requires an input
between mic and line level, or 0dB for a line level input device.
CONSOLE AI User Manual