CONSOLE AI | Introduction | 23
About Long-distance P-link
Using long-distance P-link lets P-link devices be separated from a CONVERGE Pro 2 and from one
another by up to 650 feet (198m).
Things to keep in mind:
• You can turn long-distance P-link on or off in the Device Settings dialog box. See Changing CP2 Device
Settings - General for more information.
• Long-distance P-link applies only to Beamforming Microphone Array 2 and BMA CT devices, and not to
any other P-link devices.
• Connect the devices using CAT6, 550MHz, 23AWG solid conductor Ethernet cable. Do not use Copper
Clad Aluminum (CCA) Ethernet cable.
• Any CP2 units being connected using long-distance P-link must have firmware 5.0.13.0 or newer.
• Any Beamforming Microphone Array 2 units being connected using long-distance P-link must have
firmware 1.0.3.12 or newer.
• You can connect no more than three Beamforming Microphone Array 2 or BMA CT channels to one
CP2 when using Long-distance P-link. Each speaker channel uses one of those three channels, along
with the mic channels.
About Templates
When you make adjustments to channel properties for a particular channel type, you can save all the
settings together as a template. You can save as many templates as you want and then later apply them
again when using the same channel property type in the future. Using templates is a fast, easy way to
adjust channel properties without having to repeat the same steps.
There are basically three ways to create and use channel property templates:
1. Save or apply templates from the channel properties block in FlowView or MatrixView by right-clicking
anywhere in the block and choosing Apply Template or Save As Template
2. Open a channel property block from the Channel Properties screen and then right-click anywhere in the
block and choose Apply Template or Save As Template
3. Use the Template Editor to manage templates (for more information, see Using Template Editor)
Checking for Updates
You can check for updates to the CONSOLE AI, firmware updates for ClearOne devices, CONVERGE Pro
2 Dialer, or other software ClearOne makes available.
Note:
You must have Internet access to use the Check for Updates feature.
To check for updates:
1. From the Help menu, choose Check for updates.
The Download from Web dialog box appears:
CONSOLE AI User Manual
To Next Page
Loading...
