CONSOLE AI | Online Mode (CP2) | 293
The Device Settings dialog box for that device appears. See Changing CP2 Device Settings - General,
Changing CP2 Device Settings - Network, Changing CP2 Device Settings - VoIP, Changing CP2
Device Settings - IP Phone (VoIP/SIP), or Changing CP2 Device Settings - Telco for more information.
Note:
When you are connected a device, you cannot change most of the device settings.
7.
To restart all the devices in a stack, click next to a device.
The Confirm Reset dialog box appears:
8. To reboot the stack devices, click Yes.
Note:
Restarting a device does not remove any device settings you have changed for the device. If
you want to remove all device settings, you must restore the device to factory defaults. See
Restoring a Stack to Factory Defaults (CP2) for more information.
Viewing Network Information (CP2)
You can view the following network information about the devices in a stack:
• Device Name
• Network Port IP Address, MAC Address, Subnet, Gateway, DNS, and Status
• VoIP Port IP Address, MAC Address, Subnet, Gateway, DNS, and Status
• USB Network Port IP Address, MAC Address, Subnet, Gateway, DNS, and Status
You can also locate a device by causing its Locate LED to blink, reset any device in the stack, and change
a device’s settings.
To view network information about the devices in a stack:
1. If you have not already done so, connect to a stack.
For more information about connecting to a stack, see Connecting to a Device or Stack (CP2).
2. From the Navigation Panel, select Network.
The Network screen appears:
All devices in the stack are listed here. You can see the details about any particular device.
Locate Device
3.
To locate a particular device by causing its Locate LED light to blink, click next to that device.
The Locate light on the device will blink, and the Locate LED light in the CONSOLE becomes solid: .
CONSOLE AI User Manual
To Next Page
Loading...
