ClearOne CONVERGE Huddle - Chapter 5: Adding Devices (CP2)

Chapter 5
Adding Devices (CP2)
Topics:
• Adding a CONVERGE Pro 2
Device
• Adding a Beamforming
Microphone Array 2
• Adding a BMA CT
• Adding a Bluetooth Expander
• Adding a GPIO Expander
• Adding a USB Expander
• Adding a DIALOG 20 Wireless
Mic
• Changing CP2 Device Settings -
General
• Changing CP2 Device Settings -
Network
• Changing CP2 Device Settings -
VoIP
• VoIP Dial Plan Syntax
• Changing CP2 Device Settings -
IP Phone (VoIP/SIP)
• Changing CP2 Device Settings -
Telco
• Changing Device Properties -
DIALOG 20
• Performing an RF Scan for
DIALOG 20
• Changing Stack Settings (CP2)
• Opening the Serial Commands
Reference Manual (CP2)
This chapter contains information about adding and configuring
CONVERGE Pro 2 devices and related peripherals.
Note:
The options described in this chapter are accessible only
when the CONSOLE AI is in offline mode (not connected to a
device or stack). See Online Mode vs. Offline Mode for more
information.