Clevemed SleepView - Check-In Study Data from SleepView Monitor

SLEEPVIEW USER MANUAL
21
12. A green power LED indicates that the unit is ready for the study. Turn OFF the unit
prior to sending home with a patient.
13. Upon clicking <Finish> the SleepView Manager window will close.
14. Click <Commit Study> in the webpage and you are returned to the home screen.
Check-In Study Data from SleepView Monitor
When a patient returns a SleepView, the study data must be uploaded to the portal
before it can be submitted for review and interpretation. The following instructions will
provide a walkthrough of the process of transferring data from a SleepView Monitor to
Portal.
From the home page select Step 2 Check-In Device.
1. The “Connect Device” page will appear with instructions on how to connect the
system to the PC.
2. Connect your SleepView to the computer using the USB cable provided. There is a
connection inside the battery compartment for one end of the USB cable.
3. Once the SleepView is connected to the computer, press and hold the ON button for
at least 3 seconds.
4. The power LED will illuminate. Typically, it will immediately illuminate green, but it
may also flash amber first and then green.
PLEASE NOTE: If at any point the power LED flashes red, this indicates a
serious system failure and technical support should be contacted
immediately.
5. Click <Next> and the “Download Files” screen will appear and begin to show
progress of files being transferred from the device to the computer. Two progress
bars will be shown. The top progress bar shows the progress of the current file being
downloaded. The second one shows the overall progress of the entire transaction.
6. Wait until the transaction is complete and the <Finish> button becomes available.
Press the OFF button on the SleepView until the power LED turns off and
disconnect it from the PC.
7. Click <Finish> and you will be returned to the home screen.