Clevemed SleepView - Chapter 11: Tips for Dispensing SleepView; Patient Dispensing Workflow Steps

SLEEPVIEW USER MANUAL
32
Chapter 11: Tips for Dispensing SleepView
Steps for Dispensing SleepView to patients:
 Verify that the SleepView has been cleaned (See Chapter 3)
 Use SleepView Manager software to program the study ID and recording time
 Place a new battery in the SleepView
 Turn the SleepView ON
PLEASE NOTE: Verify that the LED indicators flash green five times and that the
power LED turns green. This confirms the recording time has been programmed
and the battery is fully charged.
 Verify that the correct size belt is connected to the SleepView
 Train the patient on hooking up the sensors and give them hookup instructions
 Instruct the patient to turn OFF the SleepView by pressing the OFF button until
the LED change.
 Instruct the patient to use Smart-Check to verify diagnostic data was recorded.