22
Press to turn off the meter. The meter repeats all your settings
before shutdown.
Congratulations! You have completed all settings!
If you want to turn off an alarm, nd the alarm number by pressing
Set in the setting mode, press to change from “ON’ to “OFF”.
At the time of your alarm, the meter will beep and
automatically turn on. You can press
to silence the
alarm and insert a test strip to begin testing. If you do
not press
, the meter will beep for 2 minutes then
switch off. If you do not want to test at this time, press
to switch off.
These parameters can ONLY be changed in the setting mode.
If the meter is idle for 3 minutes during the setting mode, it will
switch off automatically.
NOTE
If you do not want to set an alarm, press
and select “OFF” to skip
this step.
Setup the remaining three reminder alarms by following instructions
above.
To Next Page
Loading...