Clevo E4120 - Ports and Jacks

Disassembly
Removing and Installing the Processor 2 - 11
2.Disassembly
Removing and Installing the Processor
Processor Removal Procedure
1. Turn off the computer, remove the battery (page 2 - 5), and the component bay cover (page 2 - 9).
2. Loosen the CPU heat sink screws in the order
, &
(the reverse order as indicated on the label).
3. Carefully lift up the heat sink (Figure 7c) off the computer.
3
2
1
4
Figure 7
Processor
Removal
a. Remove the cover
and Iocate the heat
sink.
b. Loosen the screws
in the order indicat-
ed.
c. Remove the heat
sink.

CPU Warning
In order to prevent
damaging the contact
pins when removing
the CPU, it is neces-
sary to first remove the
WLAN module from
the computer.

4. Heat Sink
•3 Screws
a.
4
1
b. c.
3
2
Note: Loosen the screws in the reverse order
3, 2, 1 as indicated on the label.