Clevo E4120 - Removing the LCD Front Cover

Disassembly
2 - 20 Removing the LCD Front Cover
2.Disassembly
Removing the LCD Front Cover
1. Turn off the computer, and remove the battery (page 2 - 5), and remove the LCD back cover (page 2 - 18).
2. Remove the rubber covers and screws - (Figure 16a), then run your finger around the middle of the frame to
carefully unsnap the LCD front cover from the LCD panel.
3. After unsnapping all four sides of the LCD front cover, carefully slide the LCD front cover downwards in the direc-
tion of the arrow (be careful of the LCD hinges at point ).
4. You can now remove the LCD front cover.
Figure 16
LCD Front Cover
Removal
a. Remove the screws and
unsnap the LCD front
cover from the LCD pan-
el.
b. Slide the LCD panel cov-
er in the direction of the
arrow.
1
4
5
6
7

5. LCD Front Cover
•4 Screws
a. b.
1
2
3
4
7
5
6
7
5

Rubber Screw Covers
After removing the rubber screw covers, place them on a
clean dry surface (or attach them to the front cover itself) in
order to prevent loss of adhesive.