Clevo N950TP6 - Removing and Installing the Processor

Disassembly
2 - 10 Removing and Installing the Processor
2.Disassembly
Removing and Installing the Processor
Processor Removal Procedure
1. Turn off the computer, remove the battery (page 2 - 5) and bottom cover (page 2 - 6).
2. Disconnect the cable and remove screws - from the CPU fan and lift it out (Figure 6a)
.
3. Remove screws - from the heat sink unit in the order indicated on the label (i.e screw first through to
screw last Figure 6b)
.
4. Carefully (it may be hot) remove the heat sink unit as shown by the arrow (Figure 6c).
1
2
3
4
5
8
8
5
9
Figure 6
Processor
Removal
Procedure
a. Disconnect the fan
cable and remove
the screws. Lift the
fan out of the com-
puter.
b. Remove the screws
in the correct order.
c. Carefully remove
the heat sink unit as
shown.

4. CPU Fan
9. Heat Sink Unit
•6 Screws
a.
4
b.
Note:
Loosen the screws in the reverse
order 4-3-2-1 as indicated.
3
5
1
2
7
86
9
c.