Clevo P150EM - Intel Wireless Display Application; Intel WiDi Application Installation; Intel WiDi Application Configuration

Disassembly
2 - 10 Removing the Hard Disk from the Secondary HDD Bay
2.Disassembly
Removing the Hard Disk from the Secondary HDD Bay
Note that the secondary hard disk (if installed) is located under the optical device bay (CD/DVD).
1. Turn off the computer, and turn it over, remove the battery (page 2 - 5) and optical device (page 2 - 9).
2. Remove the screw at point (Figure 6c), and use a screwdriver to carefully push out the secondary HDD module
at point (Figure 6a and Figure 6b).
3. When the module is removed turn it over to access the rear. Remove screws - from the secondary HDD
module assembly(Figure 6c
).
4. Remove the hard disk from the module caddy (Figure 6d
).
5. Reverse the process to install a new hard disk.

3. Hard Disk Assembly
8. HDD
•5 Screws
Figure 6
Secondary HDD
Assembly Removal
a. Remove the screws.
b. Use a screwdriver to
carefully push the HDD
module out.
b. Remove the screws.
c. Lift the secondary HDD
assembly up and out of
the module caddy.
1
6
3
2
4
7
6
8
9
a. c.
b.
9
1
2
4
8
3
d.
5
7 6