Clevo P375SM - System Startup

Disassembly
2 - 14 Removing the System Memory (RAM)
2.Disassembly
5. Gently pull the two release latches & on the sides of the memory socket in the direction indicated by
the arrows (Figure 10d).
6. The RAM module will pop-up, and you can then remove it.
7. Pull the latches to release the second module if necessary
8. Insert a new module holding it at about a 30° angle and fit the connectors firmly into the memory slot.
9. The module’s pin alignment will allow it to only fit one way. Make sure the module is seated as far into the socket
as it will go. DO NOT FORCE the module; it should fit without much pressure.
10. Press the module in and down towards the mainboard until the slot levers click into place to secure the module.
11. Replace the component bay cover and screws.
12. Restart the computer to allow the BIOS to register the new memory configuration as it starts up.
8
9
Figure 10
RAM-1 Module
Removal (cont’d.)
d. Gently pull the release
latch in the direction in-
dicated.
e. Remove the module.

10. RAM Module
10
8
9
10
e.d.