Clevo P375SM - Page 42

Disassembly
2 - 18 Removing and Installing the Processor
2.Disassembly
Processor Installation Procedure
1. Insert the CPU , pay careful attention to the pin alignment, it will fit only one way (DO NOT FORCE IT!).
2. Turn the release latch towards the lock symbol as indicated.
3. Remove the sticker from the heat sink unit (if it is a new unit).
4. Insert the heat sink as indicated in Figure 14c.
5. Tighten the CPU heat sink screws
, , & (Figure 14d) and connect the CPU fan cables (make sure
that the CPU fan cable is tuck underneath the bracket ).
6. Insert heat sink fan and tighten the screws -
(Figure 14e).
7. Replace the component bay cover and tighten the screws (page 2 - 16).
A
B
C
D
1
2
3
4
E
G
F
H
J
b.
c.
B
a.
D
H
e.
d.
E
F
C
A
4
1 3
2
F
I
J
Note:
Tighten the screws in
the order 1-2-3-4 as in-
dicated on the label.
G
Figure 14
Processor
Installation
a. Insert the CPU.
b. Turn the release latch to-
wards the lock symbol.
c. Remove the sticker from
the heat sink and Insert
the heat sink.
d. Tighten the screws.
e. Connect the heat sink
fan cables and insert the
heat sink fan. Tighten
the screws.

A. CPU
D. Heat Sink
F. Heat Sink Fan
•7 Screws