Model HF-15B High Frequency Spark Tester
HF-15B Instruction Manual – Page 41
Fieldbus Communications Interface
The model HF-15B can be purchased with an optional Fieldbus Communications
Interface. (Model HF-15BX) This interface will allow the installation of several
communication options. (DeviceNet, Ethernet IP, Modbus RTU, Modbus TCP,
Profibus, Profinet). For each interface a EDS file and support documentation
will be provided to assist in the integration.
For Parameter Addresses see the section entitled “Fieldbus Parameter
Addresses”. For the specific fieldbus specific data see the section entitled
“Fieldbus Specific Information”.
Fieldbus Communications Parameters
The following table shows the default communication parameters for the
various fieldbuses that are supported by the HF-15BX Spark Tester. See the
section entitled CIC XM Utility for the steps required to modify these
parameters. Note, the Data Sizes are fixed and cannot be changed
* This is factory set as RS-232. If two wire RS-485 or four wire RS-485 is
required, consult the factory.
** On the Profinet module is the Station Name is not set, the MS LED will flash 3
times. This value can be set by the Profinet Master.
*** Specify the Output Words first followed by the Input Words. (A Word is 16 bits)
To Next Page
Loading...