Operating instructions
3. Press Enter to accept the default (all panels).
4. On the Report Output menu, choose the following:
• Display to view the list on the alphanumeric display
Displaying a list of abnormal monitor points
Use the Monitor command on the Status menu to display a list of
monitor points (i.e., monitor inputs) that are not in the normal
condition. The list also includes any monitor-related pseudo
points.
To display a list of abnormal monitor points:
1. Press Status.
2. From the Status menu, choose Monitor.
3. Press Enter to accept the default (all panels).
4. On the Report Output menu, choose the following:
• Display to view the list on the alphanumeric display
Displaying a list of abnormal output points
Use the Outputs command on the Status menu to display a list of
output points (i.e., relay, common alarm, supervised, audible,
and visible outputs) that are not in the normal condition. The list
also includes LED-switch card LEDs.
To display a list of abnormal output points:
1. Press Status.
2. From the Status menu, choose Outputs.
3. Press Enter to accept the default (all panels).
4. On the Report Output menu, choose one of the following:
• Display to view the list on the alphanumeric display
Displaying a list of points in a fault condition
Use the Fault command on the Status menu to display or list of
points that are in a fault condition.
To display a list of points in a fault condition:
1. Press Status.
2. From the Status menu, choose Fault.
3. Press Enter to accept the default (all panels).
4. On the Report Output menu, choose one of the following:
• Display to view the list on the alphanumeric display
To Next Page
Loading...