After ensuring the cause of the alarm has been corrected, reset the panel by pressing the
RESET key on the central panel.
After resetting, the panel will return to normal operating condition, assuming that there are no
other events to raise a new alarm and the original cause of the alarm has been removed. The
operator should now record the incident in the panel log book.
3.4 Initiating evacuation
The operator can signal a fire condition manually by pressing the SOUND ALARMS key. This
has the following effects.
• Programmed sounders, other outputs will activate (this includes sounders connected to
the panel monitored alarm output)
• The common fire LED flashes
• The panel buzzer sounds
• An evacuate message appears on the display
FIRE ALARM (Zones) Total :01
01 SOUND ALARMS PRESSED 13.21
=== FIRE =========================
The alarms can be silenced by pressing the SILENCE ALARMS key. To reset the system press
the ACCEPT key followed by the RESET key.
http://www.firealarmengineers.com
To Next Page
Loading...
