4.3 Lamptest
The “ lamptest” facility is used to test the panel front LED’ s and display. The following
steps should be followed.
1. Select Operator Menu from the Main Menu giving:
Operator Menu.
1. Time & date
2. Reports to display 4. Lamptest
3. Reports to printer 5. Keypad test
2. Press 4 to select lamp test
LAMPTESTXXXXXXXXXXXXXXXXXXXX
XXXXXXXXXXXXXXXXXXXXXXXXXXXX
XXXXXXXXXXXXXXXXXXXXXXXXXXXX
XXXXXXXXXXXXXXXXXXXXXXXXXXXX
All the LED’ s should illuminate for approximately 10 seconds. Any that do illuminate are faulty
and should be attended to. To cut the test short and exit press HOME key.
http://www.firealarmengineers.com
To Next Page
Loading...
