4.2 Setting the time and date
This function allows the date and time displayed by the panel to be set. Various panel functions
are controlled by the time and date setting, so it is important to regularly check that they are
correct. If they are not then this should be corrected as described in the following steps. This
display is shown after each step.
1. Display Operator Menu as described in section 4.1
Operator Menu.
1. Time & date
2. Reports to display 4. Lamptest
3. Reports to printer 5. Keypad test
2. Press 1
OPERATOR: Time and Date
Press Up/Down to Change day.
Current date is: 01/07/1998 dd/mm/yyyy
Enter new date : 12/07/1998 (Friday)
3. Enter the day, the month and the year in that order using the numeric keys 1-9, each
taking two digits (e.g. for 12th July 1998 press the keys 12071998). Use the up and
down arrows to select the correct day. Press the ↵ (enter) key when done.
OPERATOR: TIME & DATE
Current time is: 14:11
Enter new time: 14.11
4. Enter the time in international format (four digits, hours 00 to 23, then minutes 00 to
59). Press the ↵ key when done. To exit the Operator menu Press the HOME key.
http://www.firealarmengineers.com
To Next Page
Loading...
