Having entered the individual device display the screen will revert back to the main zonal fault
screen after a short delay.
If there is more than one fault event from the same zone present, then the MORE keys can be
pressed to manually switch between the individual device information with each device
occupying a full four lines of information.
If fault events are present from more than one zone then the top level zone screen will indicate
as such. For example:
FAULTS (Zones) Total: 02
01 Z005 First Floor Offices 12:57
02 Z001 Ground Floor Offices 13:01
======== FAULT ====================
By pressing the VIEW POINTS key the user can then manually scroll through the individual
device information for all fault events from all zones in fault through using the MORE keys. If
more than two zones are in fault then the MORE LEDs will illuminate. The screen will display
the first fault on the second line and the newest zone of fault on the third line. The second line
will be used to scroll through all of the zones in fault when the MORE keys are operated.
The fault can be accepted by pressing the ACCEPT key.
The fault should be investigated and the cause corrected after which the system can then be
reset to normal condition by pressing the RESET key.
http://www.firealarmengineers.com
To Next Page
Loading...
