Replacement printer cartridges can be obtained from Clymac as ZP-PRC (product
code 24201). To replace a finished printer ribbon cartridge the following steps should be
followed.
1. Tear off any paper emerging from the printer.
2. Open printer door by pressing door switch, SW1, to the right.
3. Place a forefinger against the lower edge of the mechanism mounting chassis and
thumb against the back of the door.
4. Carefully press door and chassis in vertically opposite direction until the catch is
released. The catch must be released before pulling the door and chassis apart. open
the door fully to expose the printer mechanism and ribbon cartridge.
Figure 5.1.2 Removal of printer ribbon cartridge
5. Press down on the end of ribbon cartridge marked “ PUSH” and carefully remove
the used cartridge.
6. Fit a replacement cartridge, ensuring paper lies between the ribbon and the steel
printer plate. Snap the cartridge into place.
7. Make sure that the ribbon is taut and parallel to the paper. If necessary tighten it
by using turning the faceted disc clockwise with a fingernail.
8. If there is some paper protruding from the front of the printer check that it will pass
clearly through the guide channel and past the tear bar, then snap the chassis shut.
9. Turn paper roll by hand so that all paper is wound firmly around the paper roll.
10. Close the paper door and check that paper flows freely, using the paper feed
button SW2.
http://www.firealarmengineers.com
To Next Page
Loading...
