CM LODESTAR D8+ F User Manual

10001921 REV AC July 2019
Before installing hoist, fill in the information below.
Model Number
Serial No.
Purchase Date
Voltage
Rated Load
RATED LOADS 1/4 TO 2 TONNES
250 KG TO 2000 KG
WARNING
Follow all instructions and warning for inspecting,
maintaining and operating this hoist.
The use of any hoist presents some risk of personal injury
or property damage. That risk is greatly increased if proper
instructions and warnings are not followed. Before using
this hoist, each operator should become thoroughly familiar
with all warnings, instructions and recommendations in this
manual. Retain this manual for future reference and use.
Forward this manual to operator. Failure to operate equipment
as directed in manual may cause injury.
ELECTRIC CHAIN HOIST
INSTALLATION, OPERATING
& MAINTENANCE MANUAL
ADJUSTABLE CLUTCH MODEL
ADJUSTABLE CLUTCH UNITS IDENTIFIED WITH PRODUCT CODE PREFIX "A"

CM LODESTAR D8+ F Specifications

General

Lifting Speed	1.5 m/min
Power Supply	230V, 50Hz
Motor	Thermally protected
Chain	Grade 80
Hook	Forged steel, safety latch
Control	Pendant control
Standards	EN
Chain Falls	1

Summary

Safety Precautions

General Safety Warnings and Responsibilities

Covers critical safety warnings, operator duties, and prohibited actions.

Installation Procedures

Hoist Unpacking and Suspension Installation

Electrical Setup and Phasing

Power Supply, Voltage, and Phasing

Instructions for connecting power, changing voltage, and proper phasing.

Operating Instructions

General Hoist Operation and Load-Limiter

Safe Load Handling and Stage Operation

Inspection and Maintenance

Inspection Types, Schedules, and Hook Criteria

Outlines inspection frequencies and hook replacement guidelines.

Preventive Maintenance and Lubrication

Load Chain Inspection and Installation

Load Chain Inspection and Wear Checks

Procedures for inspecting load chain condition and wear.

Load Chain Removal and Installation

Clutch Adjustment

Clutch Adjustment Procedure and Torque Limits

Step-by-step guide for adjusting the internal slip clutch and limits.

Limit Switch Setting

Setting Upper and Lower Limit Switches

Procedures for setting the upper and lower hook travel limit switches.

Troubleshooting

Common Hoist Symptoms and Solutions

Guide to diagnosing and resolving common hoist operational issues.

Electrical Data

Electrical Component Data and Testing

Torque Specifications

Fastener Torque Specifications by Model