C.M.C. n.v. - Airmaster R1 installation guide – base unit – V1.1 – MANY0317A.00
Page 28 of 41
8. Putting into operation
Do not put the controller into operation if you have not read and understood this installation
guide.
Connect or disconnect connectors only when no power is applied.
It is not allowed to plug in any connector before connecting safety earth. Also disconnecting
safety earth is only allowed when all other connectors are plugged out. See also chapters
Safety and EMC.
Connect safety earth first and disconnect safety earth last.
Please refer to the “Airmaster R1 software specifications” for more information about the
interaction with the user after putting the controller under power
9. Configuration
No configuration necessary. The type of analogue input conditioning cards are placed on the
right position depending on the specification file.
It is not allowed to plug out analogue input conditioning cards,
otherwise permanent damage could occur.
10. Trouble shouting
The software has much trouble shouting capabilities. These will not be explained in this
document. Please refer to the “Airmaster R1 software specifications” for more information.
In case of a problem with a controller under warranty please follow the procedure, which can
be asked at simple request. Try to add as much information regarding the fault and the
circumstances of occurrence as possible.
To Next Page
