C.M.C. n.v. - Airmaster R1 installation guide – base unit – V1.1 – MANY0317A.00
Page 41 of 41
voltage potential available to the circuit is not more than 24 Vdc/ac and the current is
limited to a value not exceeding 8 amperes measured after 1 minute of operation. A
secondary fuse or other such secundary circuit protection device rated 4 A in
accordance with the UL248 series shall be used to limit the available current.
5. Spacings at factory wiring terminals of not less than 6.4mm (1/4 in) should be
maintained between any uninsulated live part and the walls of a metal enclosure.
6. The human interface module, which is used in conjunction with the Airmaster R1,
has not been subjected to enclosure tests. Suitability should be determined in the end-
use application.
To Previous Page
