CMT2310A
Rev 1.0E | Page48/50
12 Revise History
Table 25. Revise History Records
1. Update pin name NSEL to CSB.
2. Update parameter name SCL to SCLK.
3. Change the note information in Table 21 in section 8.1.
4. Change frequency deviation range in table 6 in section 1.6.
5. Change packaging size values in table 23 in section 10.
6. Some update based on review comments.
1. Update SPI interface parameter values in the table 12 in section
1.12.
2. Update 0x7B as the operation port of BRW in 5.1.2.
3. Update 0x7A as the operation port of FIFO in 5.2.1.
4. Modify SPI Sequence Chart in 5.1.2；
5. CMSA description modified and operating process added in
7.6.
1. 5.4 GPIO and interrupt，GPIO number changed to 7；
2. Update TFS and TX status arrows descriptions in figure
5.16；
7.7 Update the description of Antenna Diversity
1. 5.3 The function description of TX_RESEND_DONE is
changed to "Interruption for repeated transmission complete"
2. 5.3 The CSMA_DONE function description is changed to
CSMA operation interruption complete.
3. 5.3 The function description of TX_DC_DONE is changed to
"Duty Cycle tx interruption complete.
4. 5.1 Update the description of SPI Burst at the top of page 27.
5. Remove the function of LFXO 1 and LFXO 2 at Table 18
6.2.2 The description of Tx processing changed to " In packet
mode, the MCU must pre-loaded the FIFO with data in READY and
TFS states, and then send the go_tx command to send the data
out."
Delete the electrical characteristic description of low frequency
To Next Page
