EasyManuals Logo

CNC 6040z-s65j User Manual

CNC 6040z-s65j
15 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
11
First, we operate the XY axis through manual control, and move the principal axis close to the initial
point; Install a flat base pointed knife.
Turn off the power switch of electric cabinet (the phase step motor will not be self-locked when the
power is cut off), and then slowly wring the hand wheels for fine control on three
stepping motor
, to
move the tool nose to the initial point.
Step three: Lead in tool path code
Import G code and the test file of "your helper.nc" in the random CD to Mach3 software. Now we will do
the first engraving practice with this file;
Step four: Begin to engrave
C lick "Zero X, Zero Y, Zero Z" respectively, to reset the coordinate of X, Y, Z axial (important);
Turn on the "POWER" switch on the electrical cabinet, and then turn on the " PUMP " and "VFD-SP"
switch, please slowly turn the speed control knob, and stop when the LED display is 300 . Then, press
the "RUN" key on the control panel, and now the spindle motor should begin to rotate quickly.
Click the "Cycle Start" button in Mach3, and it will begin to engrave.
Attention: at the time engraving, prevent the hand from getting too close to the cutter with
highly revolving speed, and do not observe it in close distance. After finishing the engraving,
first turn down the revolving speed of the principal axis to the minimum; then rise Z axis in
Mach3 through manual control, and move the spindle motor outside the engraving materials;
and then turn off the power switch. Each time after finishing engraving, the scraps generated by
engraving should be cleared in time.
Summary : You have finished a whole process of engraving practice through this example.
Whatever you engrave in the future, it is of the same operation procedure as this. The key points
are as follows:

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the CNC 6040z-s65j and is the answer not in the manual?

CNC 6040z-s65j Specifications

General IconGeneral
BrandCNC
Model6040z-s65j
CategoryEngraver
LanguageEnglish