2
② Design the content that needs to be engraved through design software, and output G code or
nc, Tab files that can be recognized by Mach3;
③ Firmly clamp the materials need to be engraved on the operating platform of engraving
machine;
④ Import engraving code to the control software Mach3, send out command to the engraving
machine after passing through the code, and then the engraving machine will start to operate.
■
Requirements for the configuration of master control computer:
① The desktop computer must possess parallel ports; Notebook PC or USB parallel port
cannot be used normally.
②
Minimum configuration of the computer: CPU/1G, 512M memory, 20G hard disk,
mainboard with parallel port, WIN-XP operating system.
■ Introduction to control software and design software:
① Control software: Mach3 is recommended (EMC2 and Kcam4 can also be applied, and
consult software providers for detailed information);
② Design software: A rt CAM , MasterCAM , PowerMill and TYPE 3 are commonly used, but
there are also many kinds of other professional software.
------------------------------------------------------------------------------------------------------------------------------------------------------------
Important
Important
Important
Important statement
statement
statement
statement : we only sell engraving machine, but not including
computer and relative software. The software mentioned in this manual is
only for your convenience, so please understand, select, purchase, and use
the software on official software website in accordance with your needs.
------------------------------------------------------------------------------------------------------------------------------------------------------------
To Next Page
Loading...
General