7
Please
Please
Please
Please carefully
carefully
carefully
carefully read
read
read
read the
the
the
the above
above
above
above picture
picture
picture
picture for
for
for
for setup,
setup,
setup,
setup, and
and
and
and the
the
the
the mistake
mistake
mistake
mistake of
of
of
of any
any
any
any number
number
number
number or
or
or
or option
option
option
option
will
will
will
will lead
lead
lead
lead to
to
to
to the
the
the
the failure
failure
failure
failure of
of
of
of the
the
the
the engraving
engraving
engraving
engraving machine,
machine,
machine,
machine, or
or
or
or even
even
even
even lead
lead
lead
lead to
to
to
to accident
accident
accident
accident when
when
when
when operating
operating
operating
operating the
the
the
the
machine.
machine.
machine.
machine.
◆
Trial run and manual control test for the machine
① Check and confirm: whether the connection among computer → control box → engraving machine is
correct; whether the software installation and parameter setting are correct;
② First, do not electrify the control box, and turn the hand wheel of three step motors by hand now, you
will feel that under the condition without electricity, they may be
easily turned by hand; Then, plug in the electricity supply, and turn
on the "POWER" switch, three step motors will be self locked at this
time. Turn the hand wheel by hand again, you may fell that it is much
tighter than the moment without electricity, and it cannot be easily
turned by hand now. This states that the machine can be controlled
now, and you can send out an order to control it now.
③ Start up MACH3 software. If the "RESET" button at the bottom left corner is flashing, then click it
with mouse, and begin to operate when it is static and not flashing; (attention that for a part of the
machine types, you must first turn on the "POWER" switch of the control box, and not press the
"EMERGENCY STOP" button).
④ Now press the direction key on the keyboard, there may be some response actions from the X or Y
axis, and the digital coordinate of corresponding axis on the screen may be changed. The left and right
keys control the X axis, while the up and down keys control the Y axis , the Page-UP and Page-DOWN
keys control the Z axis; We can also control the running of each axis by the control panel of MACH3;
Press the " Tab " key on the keyboard, to call out the manual control panel of MACH3; Click the button of
X, Y, and Z by mouse respectively, to see whether three axis of the engraving machine operate or not.
(If it is abnormal, please contact with your dealer to deal with it.)
To Next Page
Loading...
General