CO/Tech J1x-JF2-210 - Motor Fault Diagnosis; Troubleshooting Motor Start Issues

19
ENGLISH
Fault localization when there
is a problem with the motor
1. Toavoidoverheatingthemotor,youshouldregularlyblowthemachineclean
orvacuumitsothatsawdustandshavingsdonotaffectthecooling.
2. Connectthesawtoanearthedoutletwithatleasta10Afuse.
3. Immediatelyreleasethepowerswitchifthemotordoesnotstartrightup.
Unplugthepowercord,checkthatthebladerunsfreely;trystartingthemotor
againifitrunsfreely.
4. Ifthemotorstopsduringsawing:Immediatelyreleasethepowerswitchand
unplugthepowercord,releasethebladefromtheworkpiece,thentrytostart
themotoragain.
5. Checkconnections,overload(severalunitsconnectedtothesamecircuit,
spotlights,etc.),range(atleast1.5mm²upto7metrelength,atleast2mm²

at7to15metreslength),cablelength(nomorethan15metres.)
Ordering spare parts
Pleasesupplythefollowinginformationwhenorderingspareparts:
• Typeofmachine
• Thetypenumberofthemachine
• Thearticlenumberofthemachine
Disposal
Followlocalordinanceswhendisposingofthisproduct.
Ifyouareunsureabouthowtodisposeofthisproduct
contactyourmunicipality.