CO/Tech MBY8-UK - Page 4

4
ENGLISH
14. When planing large materials: make sure that thematerial has table-high support when feeding and outflowing.
15. Never start theplane when materials are touching thecutter.
16. Check before planing that thematerial has no nails and other metal objects which could damage
theplaneirons.
17. Make sure before starting that theplane irons are securely placed in thecutter according to theinstructions
in this manual.
18. Always allow thecutter to reach full power before feeding in materials.
19. If during planing theplane shows any likelihood of tipping, sliding around or begins to move off its base: stop
planing and securely screw theplane to thebase.
20. Do not plane objects that are shorter than 250 mm, narrower than 19 mm, wider than 204 mm or thinner
than 5mm.
21. Make sure that work surfaces are tidy before leaving theplane.
22. Switch power to OFF and pull out electrical cable plugs from thesocket if there is something missing from
theplane or if something is damaged; likewise if something in theelectrical system is not working properly.
Replace faulty or damaged parts before planing again.
23. Adjust thecutter cover so that it covers thewhole cutter apart from thematerial being planed.
Special warning instructions for this model
• Check regularly that theplane irons and iron holders are securely in place in thecutter.
• The maximum protrusion allowed for irons’ cutting edge outside thecutter: 1 mm (± 10 %).
• Never remove anything from themachine’s cover, other than for servicing.
• Set in place thecovers and secure them before starting themachine.
• Connect ashavings extractor to theextraction hood on theplane.
• The machine should only be connected to anearthed socket.
• Check regularly that thereverse gear locks are clean and moveable.
• Always wear protective goggles.
• Never take anedge larger than 2mm.