6
device. Tracker will only be awakened by shock under ARM state, and won’t be awakened up
under disarm states.
7.1.2 Bicycle mode two
Send SMS command to tracker device “ sleep+password+space+bicycle2” , tracker will reply
“sleep bicycle 2 ok”.In case of no operation in 5 minutes, tracker will enter low power
consumption mode , GSM、GPS、LED shut off .Neither SMS nor Calling can awake tracker
device. Tracker device will be awaken by shock and send message under both ARM and
DISARM state.
7.1.3 Ordinary mode
Send SMS command to tracker device “sleep+password+space+shock”, tracker will reply”
sleep shock ok”. It will enter sleep mode if no vibration is detected. GPS、LED shut off. SMS、
Calling、Shock can awake the tracker .
7.2. Operate the tracker
7.2.1 Bicycle mode1 one is the default mode.
7.2.2 Operate the tracker device in open area.
7.2.3 ARM by inductive key: Place the Induction key on the top of
the tracker, indicator will be on. Remove the key after 3
seconds. LED indicator flashes fast, that means tracker works
under ARM state.
7.2.4 If vibration is detected under ARM state, tracker will be awaken
and work for 5 minutes.
7.2.5 DISARM by inductive key: Put the inductive key to the top of the
device rapidly for 2 times and then remove the inductive key, LED
flashes slow, that means tracker works in DISARM state. The
times put to inductive key to disarm can be configured, and check
chapter 7.11.3 for more information.
7.2.6 Tracker stop working under DISARM state.
7.2.7 Only when the tracker is working, we can do following SMS
operations.
To Next Page
Loading...
