Appendix B: Command reference
98-169085-B AT commands 130
Other AT commands
Parameters for other M2M related AT commands
The table below summarizes the available parameters for the AT commands for M2M
operation.
Command Parameters
_ICLCK
<type>,<enable>,<passwd>
_IMACLOC
<enable>,<interface>[,<interface>]
_IMACLOCAD
<action>,<interface>,<MAC Address>[,<MAC Address>]
a
_IPWSAVSCHD
<psmode>,<psvalue>
_ITREMONOFF
<active mode>,<power down delay>,<awake time of day>,<awake duration>,<polarity>
_ISMSRMT
<enable>
_ITDCIV
No parameters
b
_ILTEBLCK
<enable>
a. Up to 10 MAC addresses may be specified.
b. Type _ITDCIV? to get the input voltage (in mV) of the EXPLORER 323
To Next Page
Loading...
