Chapter 3: To get started
98-169085-B To start and stop data connections 24
To start and stop data connections
By default, you have to start a data connection manually when the terminal is ready and
connected to the BGAN network. However, you can enable automatic activation of a data
connection. See Internet and LAN connection modes on page 62.
To start and stop data connections on your EXPLORER 323, do as follows:
1. On the connected device, open your browser and type the IP address of the terminal
(default IP address: 192.168.0.1) in the address bar to access the web interface, or
On your smartphone, start the EXPLORER Connect app and select Terminal access.
2. Locate the connection package you want to start.
3. Click
to start the connection.
4. Click
to stop the connection.
For details, see To control data connections from web interface on page 47.
The icons for starting and stopping connections are only active if the
terminal is ready and registered on the network. Otherwise you cannot start data
connections.
Once a Streaming connection is started, the connection will run until you stop it.
You will be charged for the time you are connected.
To Next Page
Loading...
