What to do if COBHAM Sailor 250 FleetBroadband terminal restores factory settings and reboots the system?
If your COBHAM Marine Equipment terminal restores factory settings and reboots, press and hold the Reset button for 30 seconds. Keep holding it until the Power indicator on the terminal starts flashing orange.
How to initiate software upload on COBHAM Sailor 250 FleetBroadband if firmware is missing or corrupted?
If the firmware on your COBHAM Marine Equipment is missing or corrupted, you can initiate a software upload by pressing and holding the Reset button while the terminal is booting.
How to reset COBHAM Sailor 250 FleetBroadband terminal IP address and IP netmask to default?
To reset the IP address and IP netmask on your COBHAM Marine Equipment terminal to their default values, simply press the Reset button normally.
General| Frequency Band | L-band |
|---|---|
| Satellite System | Inmarsat FleetBroadband |
| Voice Channels | 1 |
| Power Supply | 10.5-32 VDC |
| Data Rate | Up to 284 kbps |
| Operating Temperature | -25°C to +55°C |
| Interfaces | Ethernet, USB |
To Next Page
