COBHAM SAILOR 6080 - Protective Lid for the Connector Panel; Inserting the Cable in the Spring-Terminal Connector

Chapter 2: Installation
Installing the SAILOR 6080 Power Supply 9
2222
Installation
2.2.4 Protective lid for the connector panel
The connectors are
protected by a plastic lid.
To access a connector you
have to remove the lid. To
make room for the
connector cables you must
remove the U-shaped
cutout for the respective
cable in the plastic
protective lid.
2.2.4.1 Removing the protective lid
To connect the cables you
must remove the
protective lid.
To do this, unscrew the
two screws (M3x7mm”
Torx-8) as shown in the
picture and put the lid
aside.
2.2.5 Inserting the cable in the spring-terminal
connector
The connectors are spring-ter-
minal connectors. Use a suit-
able tool to open the spring and
insert the cable in the opening
below.